Question

3 multiple choice 1 point which of the following general guidelines should be followed during transmission reassembly after an overhaul? shims, thrust washers, circlips, and gears can be installed on shafts in any order and direction. reuse old seals, gaskets, snap rings, circlips, and lock tabs if they are in good condition. check for freedom of movement of all components throughout the transmission assembly. do not use locking compound on any transmission fasteners. 4 true or false 1 point in a continuously variable transmission, poor performance at high speeds or a lack of power are commonly caused by a worn drive belt, weak driven face spring, worn weight roller, or faulty driven pulley face. true false

Explanation:

For question 3:

• Shims, thrust washers, circlips, and gears have specific installation orders and directions based on engineering design for proper function.
• Old seals, gaskets etc. may have microscopic damage even if they look good, so re - use is not advisable.
• Locking compound is sometimes used on transmission fasteners depending on the design. But checking for freedom of movement of all components is a fundamental assembly guideline.

For question 4:

• In a continuously variable transmission (CVT), the drive belt, driven face spring, weight roller and driven pulley face are key components that affect power transfer and speed performance. A worn drive belt can slip, a weak driven face spring can cause improper pulley clamping force, a worn weight roller can disrupt the variable ratio mechanism and a faulty driven pulley face can also lead to poor power transfer.

Answer:

1. C. Check for freedom of movement of all components throughout the transmission assembly.
2. True.