Question

fff: post-processing steps
use the information below to answer the question.
the most dangerous part of fused filament fabrication (fff) is removing the print
from the print bed. after the print bed has cooled, a sharp putty knife that comes with
the printer can be used. little by little, work around the print to break the connection.
it is important to use finesse and not force.
with fused filament fabrication, the minimum post - processing needed is to remove
the support structure, which usually involves sanding and cleaning the print as
well. remove the support structure by breaking it off. there will be some surface
irregularity where the support structure was in contact with the print which will
require some sanding. sandpaper has many different grit levels, ranging from 150 to
2,000. its important to start with a lower number to get the rough material off and
then move up as needed. another option is to use a file. once sanding is finished, an
epoxy can be applied for any irregularities or to add extra strength. the print can also
be primed and painted.
when removing a fused filament fabrication (fff) print
from the print bed, it is important to do which of the
following?
use finesse and not force
work as fast as possible
apply a small amount of heat
apply a high amount of pressure

Explanation:

The text explicitly states that when removing an FFF print from the print bed, "It is important to use finesse and not force." The other options (work fast, apply heat, apply high pressure) are not mentioned as important steps for this process.

Answer:

use finesse and not force