Question

question 27 of 27
which of the following are correct inspection and maintenance guidelines for fall protection systems?
select all that apply

• wash webbing and fiber rope with mild soap and water
• do not use any wire rope that has a broken wire, kink, flattened, or shiny areas
• check the harness webbing for any cuts, tears, abrasions, or undue stretching, as well as hard, stiff, or shiny spots
• do not use any rope that has a knot in it
• be sure fall protection equipment is kept clean and in good condition.
• inspect all hardware for discoloration, cracks, charring, distortion, corrosion, or pitted surfaces

Explanation:

• Wash webbing and fiber rope with mild soap and water: Cleaning with mild soap and water is a proper maintenance practice for webbing and fiber rope to remove dirt and contaminants without damaging the material.
• Do NOT use any wire rope that has a broken wire, kink, flattened, or shiny areas: Broken wires, kinks, flattened sections, or shiny areas (indicating wear) in wire rope compromise its strength and safety, so it should not be used.
• Check the harness webbing for any cuts, tears, abrasions, or undue stretching, as well as brittle, stiff, hard, shiny spots: These signs indicate damage or degradation of the harness webbing, which can affect its ability to support weight during a fall.
• Do NOT use any rope that has a knot in it: Knots can weaken the rope's structure and reduce its load - bearing capacity, making it unsafe for fall protection.
• Be sure fall protection equipment is kept clean and in good condition: Keeping equipment clean and in good condition is a fundamental guideline for maintaining the reliability of fall protection systems.
• Inspect all hardware for discoloration, cracks, charring, distortion, corrosion, or pitted surfaces: These signs on hardware suggest damage or degradation, which can lead to failure of the fall protection system.

Answer:

A. Wash webbing and fiber rope with mild soap and water
B. Do NOT use any wire rope that has a broken wire, kink, flattened, or shiny areas
C. Check the harness webbing for any cuts, tears, abrasions, or undue stretching, as well as brittle, stiff, hard, shiny spots
D. Do NOT use any rope that has a knot in it
E. Be sure fall protection equipment is kept clean and in good condition
F. Inspect all hardware for discoloration, cracks, charring, distortion, corrosion, or pitted surfaces