Question

drag and drop
1 cap
2 nut
3 nut lock
4 outer bearing
5 thrust washer
6 hub and disc
7 inner bearing
8 grease seal
9 cotter pin

Explanation:

To solve this drag - and - drop problem for the wheel hub assembly components, we analyze each numbered position:

Position 1

The component at position 1 is the "Cap" (from the list on the right). So we drag "Cap" to position 1.

Position 2

The component at position 2 is the "Nut" (from the list on the right). So we drag "Nut" to position 2.

Position 3

Looking at the list, the "Nut lock" should be dragged to the third empty position (the one with the red - ring - like component in the diagram).

Position 4

The "Outer bearing" is the component that fits the fourth empty position (the one with the bearing - like component near the nut).

Position 5

The "Thrust washer" is for the fifth empty position (the washer - like component).

Position 6

The "Hub and disc" is the large component labeled 6 in the diagram, so we drag "Hub and disc" to position 6.

Position 7

The "Inner bearing" is for the seventh empty position (the bearing - like component closer to the hub).

Position 8

The "Grease seal" is the component at position 8 (the red - colored seal - like component), so we drag "Grease seal" to position 8.

Position 9

The "Cotter pin" is the component at position 9 (the pin - like component), so we drag "Cotter pin" to position 9.

The correct drag - and - drop mappings are:

1. Position 1: Cap
2. Position 2: Nut
3. Position 3: Nut lock
4. Position 4: Outer bearing
5. Position 5: Thrust washer
6. Position 6: Hub and disc
7. Position 7: Inner bearing
8. Position 8: Grease seal
9. Position 9: Cotter pin

Answer:

To solve this drag - and - drop problem for the wheel hub assembly components, we analyze each numbered position:

Position 1

The component at position 1 is the "Cap" (from the list on the right). So we drag "Cap" to position 1.

Position 2

The component at position 2 is the "Nut" (from the list on the right). So we drag "Nut" to position 2.

Position 3

Looking at the list, the "Nut lock" should be dragged to the third empty position (the one with the red - ring - like component in the diagram).

Position 4

The "Outer bearing" is the component that fits the fourth empty position (the one with the bearing - like component near the nut).

Position 5

The "Thrust washer" is for the fifth empty position (the washer - like component).

Position 6

The "Hub and disc" is the large component labeled 6 in the diagram, so we drag "Hub and disc" to position 6.

Position 7

The "Inner bearing" is for the seventh empty position (the bearing - like component closer to the hub).

Position 8

The "Grease seal" is the component at position 8 (the red - colored seal - like component), so we drag "Grease seal" to position 8.

Position 9

The "Cotter pin" is the component at position 9 (the pin - like component), so we drag "Cotter pin" to position 9.

The correct drag - and - drop mappings are:

1. Position 1: Cap
2. Position 2: Nut
3. Position 3: Nut lock
4. Position 4: Outer bearing
5. Position 5: Thrust washer
6. Position 6: Hub and disc
7. Position 7: Inner bearing
8. Position 8: Grease seal
9. Position 9: Cotter pin