Question

fff: 3d file checklist
use the information below to answer the question.
before you print your project, go through the following checklist:

1. is it the right file type? stl or obj are common types. make sure you have the

right extension on the file.

1. where is it going to be in the print bed? it could be in the corner of the xy axis at

the 0,0 point. it could also be in the center home position, which offers the best
opportunity for not having the piece over the build volume.

1. is the print watertight? if so, there should not be any holes.
2. do you have the appropriate material? use what you feel is best for the project.

with sla, sls, or dlp printing, there will be material within the print. you want to
have an exhaust port or drain hole for the material to get out. also, having two
holes is better than one to help equalize pressure.

1. when going from one software to another, there may be differences in units, such

as going from english to metric. checking the units is important.

1. double - check the embossing and engraving detail.
2. check the tolerances for pieces that have moving parts. the rule of thumb is.25

mm.

1. have a separate folder for each project, and have a way of putting a date on it.
2. keep your eyes on the orientation of the print bed. what will have the best

surface finish? what will use the least amount of support structure?
in step 6 of the 3d file checklist, it is important to double -
check which of the following?
the embossing and engraving position
the embossing and engraving detail
the embossing and engraving color
the embossing and engraving height

Explanation:

The checklist step 6 explicitly mentions double - checking the embossing and engraving detail.

Answer:

the embossing and engraving detail