Question

1. a(n) is used to set the head of a screw at or below the of the material. use a(n) to bore holes in wood and other materials. 2. a sand - like material used to make a surface rough, graded by its called 3. the of the drill holds the drill bit. 4. to prevent an electrical shock, do not operate electric power tool without proper 5. if a flat - bottomed hole is needed in a piece of lumber, use a 6. a is used to bore holes in brick, block, and similar ma 7. a is created by a saw blade as it cuts through the mat 8. a(n) protects people from electric shock and protects equipment from damage by interrupting the flow of electricity if an electrical fault occurs. chuck ground fault circuit interrupter (gfci) forstner bit countersink masonry bit auger bit kerf ground fault protection

Explanation:

1. A countersink is used to set the head of a screw at or below the surface of the material.
2. An auger bit is used to bore holes in wood and other materials.
3. A chuck holds the drill - bit.
4. To prevent an electrical shock, do not operate electric power tools without proper ground - fault protection.
5. If a flat - bottomed hole is needed in a piece of lumber, use a Forstner bit.
6. A masonry bit is used to bore holes in brick, block, and similar materials.
7. A kerf is created by a saw blade as it cuts through the material.
8. A ground - fault circuit interrupter (GFCI) protects people from electric shock and protects equipment from damage by interrupting the flow of electricity if an electrical fault occurs.

Answer:

1. Countersink
2. Auger bit
3. Chuck
4. Ground - fault protection
5. Forstner bit
6. Masonry bit
7. Kerf
8. Ground - fault circuit interrupter (GFCI)