Question

sls: post-processing use the information below to answer the question. aesthetics dyeing the object could be dyed by the 3rd party doing the print. this will be specified at the time of ordering the print. paint and lacquer an sls print can be painted and lacquer can be applied. check to make sure the paint or lacquer is compatible with the plastic. a primer may be required. if the part needs to be watertight, a silicone coating can be used because the surface is very porous. metal plating for a metal finish on sls prints, apply a conductive layer such as zinc spray, which can be purchased at a hardware store. then the piece can be electroplated - either hot-dip or by a professional company. a professional company will have more choices, such as stainless steel, copper, nickel, gold, and chrome. when will the dyeing for an sls print be specified when using a third party? third parties will not dye prints before the print is ordered after the print is completed at the time of ordering the print

Explanation:

From the "Dyeing" section of the SLS Post - Processing information, it says "This will be specified at the time of ordering the print" when the 3rd party does the dyeing. So we match this with the option "at the time of ordering the print".

Answer:

D. at the time of ordering the print (assuming the option with "at the time of ordering the print" is option D, if the options are labeled as such. If the options are in a different order, adjust the label but the text remains "at the time of ordering the print")